Instruction Manualwww.centuryproducts.com4001-5-02 40010502Avoid injury or death -Read and understand this manual!
Adjust car seat to upright or semi-uprightposition and armrests to up position. Place forward-facing on vehicle seat.Lift seat pad flap (on certain mo
Adjust car seat to upright or semi-uprightposition and armrests to up or down position.Place forward-facing on vehicle seating positionwith a vehicle
Place forward-facing on vehicle seat. Lift seat pad flap (on certain models), check to make sure LATCH belt is properly routed through openings and at
(fig. a)(fig. b)(fig. c) (fig. d)Opening(A)(B)Pull totightenINSTALLATION - with harness system and LATCH11
Adjust harness system:Harness straps must be through slots at or just above shoulders.Place child in car seat with child’s back flat against back of c
1323(fig. a) (fig. b) (fig. c)PLACING CHILD IN CAR SEAT - with harness system (continued)Head Support(on certain models)
Remove harness system (see “Harness System -removal and re-assembly” section, page 20).Place child in car seat with child’s back flat against back of
15(fig. b)(fig. d)(fig. c)Loops(fig. a)PLACING CHILD IN CAR SEAT-without harness system (continued)Head Support(on certain models)
OPERATIONS and ADJUSTMENTS16Harness Straps (fig. a):• To tighten: Pull lower belt tab. • To loosen: Pull upper belt tab while pulling harness straps.H
17(fig. b) (fig. c)(fig. d)(fig. e)(fig. a)Lower BeltUpper BeltTightenAdjusterLoosenOPERATIONS and ADJUSTMENTS (continued)
TABLE OF CONTENTSVehicle Seat Belts... 22Locking Clip... 29Additional I
OPERATIONS and ADJUSTMENTS (continued)18Changing Harness Strap Slots:MUST use slots at or just above shoulders.A Loosen harness straps.B Remove both h
Changing Crotch Strap Slots:MUST be in slot closest to but not under child.A Turn car seat upside down, pry metal rod loose using screwdriver and pull
HARNESS SYSTEM - removal and re-assembly20Harness Removal:• Remove harness strap loops from SplitterPlates on back of car seat.• Pull harness strap ou
213HARNESS SYSTEM - removal and re-assembly (continued)Splitter Plate (Back)12
22VEHICLE SEAT BELTSTo provide the most secure installation of the car seat:• Read the vehicle owner’s manual regardingcar seat installation and seat
23VEHICLE SEAT BELTS (continued)With Harness System:The locking latch plate on some seat belts may slip and loosen after being buckled on car seat if
With Harness System:Lap belts with retractors may or may not hold a car seat securely.Follow these steps to determine if you have a retractor system t
VEHICLE SEAT BELTS (continued)25With or Without Harness System:DO NOT use with any car seat.FPassive Restraint - Lap Belt with Motorized Shoulder Belt
26With Harness System:Vehicle seat belts located forward of seat crease may not securely hold car seat. Check vehicle owner’s manual or see vehicle de
27(fig. b)FCombination Lap/Shoulder Beltwith Locking Latch PlateWith Harness System:OK to use. Follow vehicle owner’s manual forspecific instructions
IMPORTANT INFORMATIONNO CAR SEAT CAN GUARANTEE PROTECTION FROM INJURY IN EVERY SITUATION. HOWEVER, PROPER USE OF THIS CAR SEAT REDUCES THE RISK OF SER
VEHICLE SEAT BELTS (continued)(fig. a)FCombination Lap/Shoulder Beltwith Sliding Latch PlatePull28With Harness System:Pull on latch plate (fig. a). If
29You MUST use locking clip provided with car seat with a vehicle seat belt that slides freely through the latch plate or the lap beltcannot be tightl
30ADDITIONAL INFORMATION ALWAYS STORE LATCH WHEN NOT IN USE.• Locate LATCH storage loops on the underside of car seat pad (fig. a).• Fasten LATCH onto
31Tether strap may be used with car seats when usedas a belt positioning booster (without harness) tohelp keep the upper portion of the car seat stabi
32ADDITIONAL INFORMATION (continued)A cupholder has been provided with this carseat.For maintenance, follow care and cleaning instructions for seat pa
Removing Seat Pads:If using harness system, remove harness system (see Harness System - removing and re-assembly” section, page 20).Slide “J” hooks ou
Prevent serious injury or death:• Buckle must be properly latched.• Periodically inspect and clean buckleto remove objects or debris that could preven
NOTES35
PARTS LISTNOTE: Prices subject to change.How to Order:Complete the form on the following page. Your infant restraint model and serial numbers MUST bei
Subtotal:Shipping & handling*: $5.00Sales tax**:Total:* $15.00 outside thecontinental U.S.**CA 7.25%, IL 6.25%, IN 5%, NY 8.25%, OH 5.75%, PA 6%,S
WARNINGS - Prevent serious injury or death:Never put a car seat in a front vehicle seat unless recommended byvehicle owner’s manual. NationalHighway T
Fold instruction manual.Store in pocket.If a part is damaged, missing, or you need help or replacement parts, DO NOT return car seat to the store.CALL
3WARNINGS - Prevent serious injury or death (continued):DO NOT use car seat if it is damagedor has missing parts. DO NOT use accessories or partsother
BASIC INFORMATIONWith Harness System:Car seat meets or exceeds all applicable requirements of Federal Motor Vehicle Safety Standard 213 for use in mot
VehicleTop Tether AnchorPointsVehicle Lower AnchorPointsVehicleSeat CreaseTypical seat in a passenger vehicle.Other vehicle types may have different L
LATCH System:LATCH consists of a permanently attached lower anchorage belt and a top tether strap (Fig. a).ONLY use LATCH in a seating position recomm
Child MUST meet all of the following requirements:• Weight is 20 - 40 lbs. (9 - 18 kg).• Height is 27 - 43 inches (69 - 110 cm) tall.• Child is able t
Komentáře k této Příručce